Hi Roman,

Just a couple of things I've noticed in the proggy :

1) Arrowing up & down in the Profiler list does not update the DatFile Information window. Only clicking on an item displays this info.

2) Even though I have the option View -> Keep Scanner Output enabled, it seems when I run the batchmode, this information is not saved (at least, it wasn't when I last checked!).

Cheers,

SK.

Just a little 'wish list' item.... if you run a scan over a path that has no set in it, you get a message saying 'no sets found in path, etc'.

When running in batchmode, could this message be turned off?

> 1) Arrowing up & down in the Profiler list does not update the DatFile

Yes...will check that...normally it should work since I capture the list's selection change messages...Maybe it uses a different message when using the keys to change the selection.


> 2) Even though I have the option View -> Keep Scanner Output enabled, it seems
> when I run the batchmode, this information is not saved (at least, it wasn't
> when I last checked!).


Hmm...that should work. Anyway...will test it later.

Roman Scherzer
ClrMamePro

> When running in batchmode, could this message be turned off?

Hmmm.....rompaths should have at least one valid named romset in 99% of all cases ;)


Roman Scherzer
ClrMamePro

> > When running in batchmode, could this message be turned off?
>
> Hmmm.....rompaths should have at least one valid named romset in 99% of all
> cases ;)
>
>
> Roman Scherzer
> ClrMamePro
>
I guess I'm one of the 1% then ;)

> > 1) Arrowing up & down in the Profiler list does not update the DatFile
> > 2) Even though I have the option View -> Keep Scanner Output enabled, it seems
> > when I run the batchmode, this information is not saved (at least, it wasn't
> > when I last checked!).
>




both fixed for the next version....

Roman Scherzer
ClrMamePro