I'm having some troubles getting clrmamepro to work. I've been using it for years, and never had a problem until recently.

Now when I drag updated roms into the Scan Results window, it brings up the "Do you want to rebuild..." popup. Then when I say "Yes" a window pops up for a second and then it does the fastscan again.

Is there any settings I need to get this to work?

The roms I'm dragging in are all zip files (tested working) and they have the missing roms (or some of them).

I did also make sure that all the files are not set to readonly or anything like that.

Any / all help would be great! Thanks!

a) you didn't enable all sets. Check Scanner->ScanResults->Setinformation if you got all sets enabled
b) similar, check if all systems are enabled. Scanner->Systems
c) maybe the zips are bad, check rebuilder's/scanner's warnings window for possible error messages
d) you run Vista and try to work with UAC protected folders
e) you try to rebuild to/from a folder where you don't have access to
f) check the rebuilder settings, there are some rebuilder advanced options like "skip creation when file exists in rompath" or "remove sourcefiles without rebuilding" which actually don't rebuild files
g) check the rebuilder log file (if enabled) or the rebuilder statistic window for info.
h) what do you actually expect? If you drop a file which already exist, it may be that quick.


Roman Scherzer

I ended up just reseting all the setting... and starting over... everything just started working again.

not sure what it was...

Anyway, thanks for your help!