Hi Roman,
when using batchrun in the initial dialog window the "scanner" -> "Always delete fixdatfiles (if empty)" checkbox always reset to unchecked from one session to the other. Is it possible to keep it checked? maybe using some special setting in cmpro.ini?

ciao
f205v

hmm...have to check this. If I remember correctly the fixdat options are global, so they shouldn't be affected by a batchrun. Will check it...


Roman Scherzer

hmm...it stays checked here....weird....so you say you check it before a batch run and afterwards (for the next batchrun) it's unchecked????


Roman Scherzer

> hmm...it stays checked here....weird....so you say you check it before a batch
> run and afterwards (for the next batchrun) it's unchecked????
>
>
> Roman Scherzer
>
No, let me explain it step by step:
1) I select 2 datfiles
2) batchrun windows pops up and "Always delete fixdatfiles" is unchecked
3) I check it, complete the batchrun and CLOSE cmpro
4) I reopen cmpro, load 2 datfiles, get into batchrun and "Always delete fixdatfiles" is unchecked again.
All other settings in batchrun remain the same from one session to the following, only "Always delete fixdatfiles" is reset back to unchecked.
It doesn't happen from one run to the following, it happens from one session to the following (closing cmpro in the middle)



ciao
f205v

oopsi..yeah...it's not saved at all...will be fixed in next version


Roman Scherzer

> oopsi..yeah...it's not saved at all...will be fixed in next version
>
>
> Roman Scherzer
>
Thank you Roman.

ciao
f205v