> Under Visual Pinball, go to "Preferences," then "Keys." From their you can
> change both flippers, tilt left, right, and center, and the plunger buttons.
>
Ok, Make your change for the flippers in Visual Pinball and then edit S11.VBS and WPC.VBS and change these lines:

The original lines in S11.VBS:
Private Const keyInsertCoin1 = 4 '(3) Specify Keycode for Inserting a Coin
Private Const keyInsertCoin2 = 5 '(4) Specify Keycode for Inserting a Coin

To the following in S11.VBS:
Private Const keyInsertCoin1 = 46 '(C) Specify Keycode for Inserting a Coin
Private Const keyInsertCoin2 = 47 '(V) Specify Keycode for Inserting a Coin

The original lines in WPC.VBS:
Private Const keyInsertCoin1 = 4 '(3) Inserting a Coin
Private Const keyInsertCoin2 = 5 '(4) Inserting a Coin

To the following in WPC.VBS:
Private Const keyInsertCoin1 = 46 '(C) Inserting a Coin
Private Const keyInsertCoin2 = 47 '(V) Inserting a Coin

This will allow you to use 'C' and 'V' as you coin ups and '3' and '4' for your flippers.

I hope this helps... I will work on a better WPC and S11 setup for the HotRodSe when I get home. These changes were based on the latest releases of WPC and S11.

TurboSnail2k
WIP '77 Gottlieb SS Cleopatra